|
|
2700
Impact Resistant Molded Fiberglass Doors
Technical Data
- The sections are 2” thick with a formed fiberglass face
and a 25 gauge (.0186 min.) flush steel interior skin painted
white
- Factory finished in white, almond, evergreen, mahogany,
walnut and oak or unfinished (gray) for field painting or gel
staining
- Thermally-broken for optimum weather protection
- Concealed steel plates run continuously from top to bottom
of each section for fastening hardware
- White painted end stiles
- Bottom weather seal utilizes an aluminum retainer and
extruded virgin vinyl
- Available widths: 8’, 9’, 10’, 16’, 17’ and 18’
- Available heights: 7’ to 14’ in 3” height increments
(except 8’3”, 8’6” and 10’3”)
- R-Value 14.44
Note: Unfinished doors are for field gel staining only.
Follow directions provided by gel stain manufacturer. If field
painting is desired, the door must be factory finished
(painted) prior to any painting in the field. Use only oil
based or acrylic latex house paint when repainting doors.
DOOR INSULATION
The sections are 2” thick with a formed fiberglass face
and a 25-gauge flush steel interior skin that is
thermally-broken for optimum weather protection.
2700 R-value - 14.44
|
